Stain Free Diy Ceramic Tile Grout Matt Colors Smooth Paste Appearance

DIY CERAMIC TILE GROUT - Matt Colors | Stain Resistance | Anti-mould | Waterproof |

^{Perflex Matt Epoxy Tile Grout P-20 is a two-component epoxy joint grout, made of high-tech polymer epoxy resin with fine sand, hardener, high-grade pigments and additives. It is a semi-fluid liquid, packed into two-component plastic cartridge packaging, it can easily operate by automatic caulking gun.  Matt Epoxy Grout P-20 has matt, elegant color, such as each color is same natural look as cement grout but significantly anti-mildew, stain resistance, the color also fits the natural overall decorative design.} 

^{It has high bonding strength, excellent physical properties such as non-sagging, tear/scratch/wear resistance. After curing, it is super anti-mildew, anti-bacterial, stain resistance, waterproof, moisture-proof, colorful, durable, smooth as porcelain, hard as diamond, natural as sanded cement, easy to clean, etc. The construction is very simple and convenient.}

EASY AND CLEAN GROUTING

^{Perflex Epoxy Grout P-20 is suitable for bonding, filling and beautifying the joint of ceramic or stone building materials such as ceramic tile floor, ceramic tile wall, washbasin, bathtub, toilet, kitchen table, door-crossing stone, etc.}

^{1. After the mortar solidified, the ceramic tile crevice must be cleaned, the impurities and dust in the ceramic tile crevice must be cleaned up with wallpaper knife and vacuum cleaner.}

^{2. Use cleaning wax on both sides of the gap beforehand with proper amount, pay attention not to wipe wax into the gap.}

^{3. Twist the tube cap, install it on the head of the double-tube sealant, cut the spiral rubber nozzle obliquely at the head by 45 degrees (the opening size depends on the size of the tile seam), and then install it in the rubber gun.}

^{4. Extrude about 20 cm colloid (in order to mix it fully and remove bubbles), then inject the glue into the crevice of ceramic tile.}

^{5. Press the ready glue on the crevice with with the seam press or steel ball.}

^{6. After 4-24 hours (depending on the temperature), the glue cures completely, scrape off the excess glue on both sides of the gap with a scraper.}                                                          

^{400ml per plastic cartridge, 20 Cartridge per carton.}

^{24 months if the product is stored in a dry and cool place away from light.}

^{1. The Storage of sealant should not be less than 5℃.}

^{2. Construction temperature is suitable in the range of 15-30℃, too low temperature will affect the curing time and strength.}

^{3. Impurities, dust, grease, clear water and other substances shall not be allowed during construction.}

^{4. Do not touch or trample until the sealant is completely cured.}

^{5. After use, the remaining glue can be put on the cover and can continue to use.}