P-80 Epoxy Stone Bonding Adhesives Quick Set Colored Odorless No Sagging

P-80 Stong Marble Bonding Adhesive, Super Good Bonding, Odorless, Non Sagging, Colored

^{PRODUCT INTRODUCTION
BONDPRO E-80 is a bi-component epoxy adhesive, made of high-tech polymer epoxy resin, hardener, high-grade pigments and additives. It is pre-dosed automatically thanks to the cartridge where it is packaged. Part A and part B are located in two separate pipes, using the special nozzle-mixer together with the caulking gun with two pistons, the correct dosage of the components is obtained. Regular polish and matt colors series are available.}

^FEATURE

• ^{It has high bonding strength, excellent physical properties such as non-sagging, tear/scratch/wear/chemical resistance.}
• ^{Quick dry and suitable working time that save the time of the fabrication procedure.}
• ^{Colored grout that can fit the color of marble, stone, etc perfectly.}

^{APPLICATION
PREBOND P-80 is developed for bonding marble, stone, granite, quartz and ceramic, for external and internal use.}

^{AVAILABLE COLORS}

<sup>CONSTRUCTION METHOD
1. After the mortar solidified, the joint of marble, tile, stone, etc must be cleaned, dried.
2. Use cleaning wax on both sides of the joint beforehand, pay attention not to wipe wax into the gap.
3. Twist the tube cap, install it on the head of the double-tube sealant, cut the spiral rubber nozzle obliquely at the head by 45 degrees (the opening size depends on the size of the tile seam), and then install it in the caulking gun.
4. Extrude about 20 cm colloid (in order to mix it fully and remove bubbles), then inject the glue into the joint that should be bonded
5. Press the ready glue on the joint surface with with the pressing plate.
6. After 3-6 hours (depending on the temperature), the glue cures completely, scrape off the excess glue on both sides of the gap with a scraper.</sup>

^{MECHANICAL PROPERTY}