Grouting Tips Perflex Tile Grout / Sealer Article Easy To Clean

GROUTING TIPS | PERFLEX TILE GROUT | Stain resistance | anti-mould | Easy to clean

^{The construction of dual cylinder tile grout must be done in accordance with the steps. The correct procedure: cleaning the joint, pasting the aesthetic paper or waxing, gluing, pressing the joint, and shoveling the glue. Some tips help you grouting perfectly.}

^{1.  Clearing the joint before caulking
Before caulking, the joint of ceramic tile must be cleaned, do not leave obvious dust and water stain. Some users are very excited after getting the tile grout, they immediately construct without cleaning the joints. At this time, there is a lot of dust in the cracks, some of which are very wet, and there are obvious caulking marks. The grout is seriously not dry, turn white, fall off and so on.}

^{2. What's depth of the joint is suitable for grouting
The gap should not only be kept clean, but also have a certain depth. The best depth of tile gap is about 3mm. Many users worry that the depth of the gap is not enough, and the tackifier is easy to fall off. In fact, the adhesion of the tackifier not only requires the depth, but also requires the cleanliness of both sides of the gap. The deeper the joint is, the more demand for the beautifying agent is, which also increases the difficulty of cleaning the joint.}

^{3. Caulking the tile 7days after being pasted.
After the tiles are pasted for 7days, the joint is clean and dry, which is very suitable for caulking. However, many users start to make grouting immediately when the tiles are just pasted. We should wait until the tiles are completely dry before doing the grouting. Otherwise the bottom of the newly pasted tiles is wet, which will cause the grout to be white and have color difference.}

^{4. Treatment on the top side before grouting 
Tiles with smooth surface can be grouted directly. Tiles with rough surface need to be pasted with masking paper or applied with cleaning wax. But many owners feel that this is too troublesome, or do not know which kind of ceramic tile belongs to rough surface, so they directly apply grout, which eventually leads to the destruction of the ceramic tile glaze, that the extra grout can not be directly removed.}

^{5. When press the grout is suitable?
After grouting, it is necessary to wait for a while before pressing the grout ( only for P-20), so as to ensure that a sufficient amount of the grout penetrate into the seam, so as not to waste the tacking agent and press out the flat joint.} 

^{6. When can remove the grout pressing the grout ?
There are two types of shoveling, one is pasted with masking paper, the other is waxed or directly glued. In both cases, it is not allowed to shovel the glue immediately after pressing the grout. If the glue is not dry, it will shovel off the cracks together. Those pasted with masking paper can be torn off 10 minutes after the completion of gluing. For waxed and direct gluing, they need to wait until grout is fully cured before applying the glue.}